Mastidek Laurent Cartridge Glue for Cosentino Dekton is a new generation bi-component resin used to glue Dekton. Dekton Mastidek Fast Outdoor Cartridge glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in a short time...approximately 45-60 minutes. The hardened product is very shiny and is very polishable.
This product is produced in special cartridges with a 2:1 bi-axial quantity 215 ml. The glue and hardener are pre-dosed in the cartridge which, once inserted in the proper gun, with the special mixer fixed on top, allows the correct extrusion and mixing of the product. Requires use of special M200XMR Cartridge Gun. Suitable for outdoors.
All surfaces must be cleaned and free of dust and grease. When applying to a polished or glossy surface it is advised to scrub the surface with sandpaper before gluing. Remove cap and attach the special threaded mixing nozzle. Squeeze out about 6" of Laurent glue before applying to surface. Clean the nozzle after use, replace the cap and discard the mixing nozzle. Repeat this process at any change of mixer. After usage, clean the nozzle, replace the cap and discard the mixer after. Product will not set below 32°.
The product in the cartridge will last at least 12 months if stored between 65° and 77°. Keep away from sunlight, heat and humidity.
Please read the Laurent Safety Data Sheet before use and follow the product instructions.
Technical information for the Mastidek Cartridge is available below. For a printable version of the technical information (including the data below) follow the "Printable Tech Sheet" link below the table.